EUROM E-CONVECT Manuel D'utilisation page 16

Description, Composition and Installation
Remove all packaging material and keep out of reach of children.
You will find: - the heating panel
- wall mount material (4x) with drill (8mm)
- foot (2x)
After removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance, but
contact your vendor for inspection or replacement.
Do not use the heater before it has been installed in accordance with the following
This radiator can be used as a free-standing device or mounted on the wall.
What is unique about the E-convect, is that it can be
painted. You can paint the E-convect in any colour you
wish, with any water resistant paint. Do not paint the box
with the switch and remove the plug from the socket
before you start painting. Allow the panel to dry before
using it again!
instructions!
16
1 – heatpanel
2 – Control panel
3 - electric cable with plug
4 – base
Control panel:
1 – heatpanel
A. ON/OFF switch & pilot light
B. Temperature sensor
C. Display
D. Up/down key