Publicité
Les langues disponibles
Les langues disponibles
Free-standing:
Secure the feet supplied to the underside of the radiator (see
diagram):
Place both feet on the ground, ± 50 cm. apart, screws to the
back
Slide the heating panel into the slot of the feet, so the panel
sticks out ± 5 cm on each side. The switch is at the top right,
at the rear (see fig. on front of this booklet).
Secure both screws and thereby clamp the panel in the feet.
Your E-convect is ready to use.
Mounted on the wall:
The heater must be at least 150 mm removed from all objects, walls, etc.; the distance
to the floor must be at least 200 mm and there must be at least 150 mm above the
heater.
Choose a firm, smooth, vertical wall of heat resistant material.
Mark the places where the holes are to be drilled (fig. 1).
Drill the holes at the marked places with the drill provided (fig. 2).
Tap the distance plugs as far as possible into the drill holes; the E-convect will now
keep sufficient distance to the wall (fig. 3).
Hang the E-convect with its 4 holes over the 4 plugs on the wall (fig. 4). Check
whether the distance to the floor is at least 20 cm!
Now screw the 4 bolts through the E-convect into the plugs (fig. 5)
Press the cover caps over the heads of the bolts; for extra safety you can use some
regular glue (fig. 6).
To remove the E-convect from the wall, you open the caps and unscrew the bolts.
Use and Working
Make sure the heater is not damaged.
Insert the plug in the socket
Turn the switch on (I): the light will turn on
To switch the E-convect off, you turn the switch off (O); the light goes out.
Remove the plug
from the socket.
17
Publicité
