Güde GSE 2501 Mode D'emploi page 18

Generator Turning Off
Fig. 7
Operator Safety Instructions
See General Safety Instructions and Initial Operation Safety Instructions.
• Do not use the machine until you have read the instruction manual carefully.
• Observe any safety instructions included In the manual.
• Be responsible to the others
Troubles – Causes – Troubleshooting
Trouble Cause
1.
2.
The engine w ill not
3.
start up .
4.
5.
6.
1.
Engine runs unevenly
2.
•
•
•
No current from
generator.
Inspections and Maintenance
Regular cleaning and maintenance is essential for perfect functioning and long service life of the unit.
No sm oking in the course of the described jobs.
Never w ork close to sparks, flam es or open fire.
Fuel cock closed
No fuel
The starter pull too w eak
The ignition plug too distant
Ignition plug socket loose, w et
Ignition plug socket loose
Too little oil in the tank
Too small appliance
Ignition system not in order
Poor fuel
Short circuit
Defective cable
Loose cable
• Make sure that NO appliance is connected.
• Put the on/off sw itch in OFF position.
• Turn the fuel cock to OFF.
Troubleshooting
1.
Make sure that the fuel cock on/off
sw itch are in on position
2.
Make sure that there is enough fuel in
the tank.
3.
Pull the starting cable stronger.
4.
Make sure that the ignition plug is
properly mounted.
5.
Make sure that the ignition plug cable is on the
plug. Clean the plug and check the electrode
distance.
6.
Replenish the oil
1.
Make sure that the plug is properly
mounted. Make sure that the plug cable
is on the plug. Clean the plug and check
the electrode distance.
2.
Make sure that the used fuel is correct.
1.
If the light indicator is off, the defect is
impossible to be cleared by yourself. .
If the light indicator is on :
2.
Press the overloading protection for the
required output.
3.
Check the connection
4.
Check w hether a short circuit or overloading is not
the cause.
18