Connecting The Battery - Sabo 92-13H Mode D'emploi

eng 10
Push the pin in using a hammer, ensuring that it comes completely through to the
opposite side.
NOTE
the same size as the pin to push it in the last part.
FITTING THE SEAT
Fit the seat (1) onto the plate (2) using the
screws (3).

CONNECTING THE BATTERY

The battery (1) is situated in a compart-
ment under the seat and is held in place
by a spring (2).
Connect the two red cables (3) to the pos-
itive terminal (+) and the three black
cables (4) to the negative terminal (–)
using the supplied screws and following
the illustrated sequence.
Recharge the battery according to the
manufacturer's instructions
IMPORTANT
ting in, never start the engine until the battery is fully charged!
ATTENTION!
!
safe handling and disposal.
To avoid damaging the hub, use an awl or a screw-driver of
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
UNPACKING AND ASSEMBLY
2
3 3
3
4
1
1 2