Sabo 92-13H Mode D'emploi page 101

HOW TO USE THE MACHINE
STOP FORWARD MOVEMENT, in order not to
block the collector channel, and disengage the
blades, which will stop the audible signal.
To empty the grass-catcher,
– pull out the lever (1) and lift the grass-catcher;
– close up the grass-catcher so that it hooks onto
the pawl (2).
NOTE
may be heard when the blades are engaged even
when the grass-catcher has been emptied. This is
due to grass cuttings left on the sensor of the
micro-switch. To stop the signal, disengage the
blades and then immediately engage them again.
Always keep the sensor (3) free of grass-cuttings.
Summary of the conditions whereby the safety devices permit or stop work
The safety devices work in two ways:
– by preventing the engine from starting if all the safety requirements have not
been met;
– stopping the engine if even just one of the safety requirements is lacking.
a) To start the engine it will be necessary that:
– the transmission is in "neutral";
– the blades are not engaged;
– the operator is seated or the parking brake is engaged.
b) The engine stops when:
– the operator leaves his seat when the blades are engaged;
– the operator leaves his seat when the transmission is not in "neutral";
– the operator leaves his seat with the transmission in "neutral" but without
engaging the parking brake;
– the grass-catcher is lifted or the stone-guard is removed when the blades are
engaged;
– the parking brake is engaged without disengaging the blades.
The table below shows various operating conditions, highlighting why the safety
device shuts down the engine.
At times the audible warning
eng 23
1
2
3