Installation And Connection - Bartscher AT 110 Mode D'emploi

5.2 Installation and connection

ATTENTION!
Installation and maintenance operations may only be performed by qualified
professionals!
•
Discard the complete packing material after unpacking the device.
•
Place the device on a flat, stable floor space which can support the weight and is not
sensitive to heat.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
NOTE!
The device is not a built-in device and should not be installed as such!
•
Carefully remove the protective foil from internal surfaces to avoid leaving any
adhesive tape. If any adhesive tape does remain stuck, remove it using an
appropriate agent.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
- 23 -