Mesto FERROX PLUS 3565P Mode D'emploi page 18

GB IRL
Fault
The nozzle does not spray
even though pressure is
present.
Safety valves blows off too
early.
The shut-off valve does not
close.
Liquid emerges without the
lever being activated.
Pressure gage is not indicating
any tank pressure.
Warranty
discovered during the warranty period, MESTO or the distributor in your country will repair the device
defective parts.
If such defects are discovered, please contact us immediately. We require the invoice or cash register
receipt for purchase of the device.
occurred due to improper use or unforeseeable circumstances.
CE Declaration of Conformity
according to EC Machinery Directive 2006/42/EC, Appendix II, No. 1A.
We,
MESTO Spritzenfabrik Ernst Stockburger GmbH
Ludwigsburger Straße 71
D-71691 Freiberg
declare under our sole responsibility that the products high-pressure spraying devices of the series
3565, 3585, 3595, 3615 from factory number 1289536 in the version supplied comply with all relevant
provisions of the Directive 2006/42/EC. Furthermore, the device complies with the Directive
2014/68/EU for pressure equipment.
Rolf Rehkugler, Ludwigsburger Str. 71, D- 71691 Freiberg, is authorized to compile the technical
documentation.
Freiberg, 25.04.2016
Bernd Stockburger - Managing Director –
0516
AUS USA
Cause
Valve disk [23] dirty of
defective.
Filter [22] and / or nozzle
[21] blocked.
Safety valve [12] is defec-
tive.
O-ring [24] on the pressure
bolt not greased.
Defective pressure bolt [25]
or O-ring [24].
Pressure gage [16] defec-
tive.
Original operating instructions
18
NZ CDN
Remedy
Clean or replace the valve disk.
.
.
Grease the O-ring of the pressure
bolt or O-ring. .
Sever attachments (at top, at bottom,
Open panel
[27], unscrew pressure gage [16] with
wrench and replace.
insert panel [27]. .
.
IND
6093720