Troubleshooting
Problem
Mower fails to start 1.Safety key not plug in the
Mower stops while
mowing
Mowing cutting
grass unevenly
Mower not
mulching properly
Mower vibrating at
higher speed
Wheel drive does
not work well
Possible cause
mower
2.Motor/blade disengaged
3.Battery discharged
4.Mower housing clogged
with grass and debris
1.Discharged battery pack
2.Cutting too much grass
3.Clogged mower deck
4.Overload protector in the
mower or battery pack
tripped
1.Cutting device is worn
2.Lawn rough or uneven
1. Mower deck clogged
2.Wet grass
3.Excessively high grass
4.Dull blade
1. Cutting blade is
unbalanced
2.Blade is loosen
1. The Bowden cable is
loosen
2. Dirty block the wheel drive
system
3. Rusty on drive pinion
4. Gear box defective
Solution
1.Insert safety key in the mower
2.Press the switch button and
engage the switch lever
3.Charge battery
4. Unclog mower housing
.Make certain blade is free to
move.
1. Charge battery
2.Raise cutting height
3.Unclog mower deck. Raise
cutting height, or cut a
narrower swath.
4.Rest and cool down the
mower or battery pack works
before starting the working.
1. Replace with a new one
2.Raise the cutting height to a
higher position
1. Unclog mower deck. Make
certain blade is free to move.
2.Do not mow when grass is
wet, wait until later to cut.
3.Mow once at a high cutting
height, then mow again at
desired height or make a
narrower cutting swath
4.Sharpen or replace blade
1. Balance the blade by grinding
each cutting edge equality.
2. Tighten the blade bolt.
1.Adjust the Bowden cable
2.Clean any dirty away from the
wheel drive ,belt and gearing
3.Lubricate the freewheels
(drive pinion on drive shaft)
with spray oil)
4.Contact the service-workshop
91