Publicité
Les langues disponibles
Les langues disponibles
5.5 Operating the audio player
Using the audio player, it is possible to re-
play MP3, WAV and WMA audio files from
USB flash drives, USB hard disks with sepa-
rate power supply, and memory cards of up
to 32 GB .
Note: Due to the large number of storage device
manufacturers and device drivers, it cannot be guar-
anteed that all storage media are compatible with
the player .
1) To replay audio files by means of the audio
player, use the input channel CH 1: Set the
input selector switch (6) of the channel
CH 1 to the position MP3 .
2) To replay audio files from a memory card,
insert the memory card into the slot for the
SD card (3) [notched corner downwards
and facing the unit] .
To remove the card, push the card into
the slot until it disengages .
3) To replay audio files from a USB storage
device, insert a USB flash drive, for exam-
ple, into the USB port
a USB hard disk to the USB port .
4) Replay of the audio files will start after the
USB storage device or the memory card
has been loaded . Various indications will
appear on the display (1) for information;
please refer to chapter 1 .1, item 1 . Use the
buttons (10) located beneath the display
to operate the audio player .
Button
Function
MODE
switch between
= USB port (2)
U
= slot for SD card (3)
S
= Bluetooth receiver
Bluetooth
To activate or deactivate the audio
player, press the button for 2 s .
II
switch between replay and pause
stop the replay
select the replay mode
The mode will be indicated in the first
line of the display:
= all titles continuously replayed
A LL
one after the other
= all titles of the current
F OLDER
folder continuously replayed one
after the other
= current title continuously
S INGLE
replayed
= all titles continuously
R ANDOM
replayed in random order
I I press briefly for previous / next title
keep pressed to adjust the volume
F−
go to the previous folder
F+
go to the next folder
EQ
select sound adjustment
The selected adjustment will be briefly
indicated in the second line of the
display:
NORMAL, ROCK, POP, CLASSIC,
JAZZ, COUNTRY
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
10
5.6 Operating the Bluetooth receiver
The Bluetooth receiver can be used to estab-
lish a radio communication to a Bluetooth
signal source (e . g . notebook, Smartphone,
tablet PC) which allows the mixer to replay
audio files stored at the Bluetooth signal
source .
Note: The Bluetooth signal source must be compat-
ible with the A2DP protocol (Advanced Audio Distri-
bution Profile); otherwise, no radio communication
will be possible .
1) To replay audio files by means of the Blue-
tooth receiver, use the input channel CH 1:
Set the input selector switch (6) of the
channel CH 1 to the position MP3 .
2) To switch to the Bluetooth receiver, press
the button MODE (10) repeatedly until
Bluetooth
3) Activate the Bluetooth function at the
notebook, the Smartphone or the tablet
PC and establish the connection to the
mixer (please refer to the instructions of
(2) or connect
the respective device, if necessary) . On the
display of the Bluetooth signal source, the
mixer is indicated by "Bluetooth" .
4) Once the Bluetooth connection has been
established, the display will show
nected!
5) Use the buttons of the Bluetooth source
for operation (replay, pause, title selection)
or the button II for replay / pause and the
buttons
6) To adjust the basic volume, keep the but-
ton I or I (24) pressed (adjustment
range
(chapter 5 .6)
7) To switch to audio replay from a memory
card or from a USB storage device, press
the button MODE repeatedly until
appears in the first line to the left of the
display .
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
appears on the display .
I and I for title selection .
I
to
) .
VOL: 00
31
6 Specifications
Inputs
(sensitivity/ impedance; connection)
MIC: . . . . . . . . . . . . . . . . 1 .5 mV/ 600 Ω;
LINE, AUX: . . . . . . . . . . . 200 mV/ 6 .6 kΩ;
PHONO: . . . . . . . . . . . . . 2 mV/480 kΩ;
Output level
XLR jacks MASTER: . . . . . 1 .5 V at indica-
RCA jacks MASTER: . . . . 1 V at indica-
RCA jacks REC: . . . . . . . . 0 .4 V
6 .3 mm jacks BOOTH: . . . 1 V
Headphone impedance: . . ≥ 8 Ω
Frequency range: . . . . . . . 20 – 20 000 Hz
THD: . . . . . . . . . . . . . . . . . < 0 .15 %
S / N ratio: . . . . . . . . . . . . . > 60 dB, un-
Tone controls
CH 1 ... CH 4
bass frequencies: . . . . ±15 dB / 50 Hz
Con
high frequencies: . . . . ±15 dB /10 kHz
DJ-MIC
bass frequencies: . . . . ±12 dB / 100 Hz
high frequencies: . . . . ±12 dB / 7 kHz
Power supply: . . . . . . . . . . 230V/ 50 Hz
Power consumption: . . . . 15 VA max .
Ambient temperature: . . . 0 – 40 °C
Dimensions (W × H × D): . 482 × 88 ×
Weight: . . . . . . . . . . . . . . 2 .9 kg
or
S
U
Subject to technical modification .
6 .3 mm jack,
unbalanced
RCA
RCA
tion 0 dB
tion 0 dB
weighted
125 mm, 2 RS
Publicité
