Remove Inside Parts - Berbel BKH 80 ST Manuel D'utilisation

Installation
3.4.3

Remove inside parts

D ATTENTION!
Danger of property damage through falling parts!
When moving the device, the front panel may open and
parts lying inside could fall out.
☞ Remove the parts lying inside before installation.
☞ Open the front panel.
☞ Lift the lower section out at the rear edge.
☞ Take hold of the lower section at the sides to remove it.
6003417_a – 26.09.2017
The Capillar Traps are inserted and held in place in the device
by magnets.
☞ Grasp the Capillar Traps on the sides with both hands.
☞ Pull the Capillar Traps out.
☞ Remove the two screws.
☞ Remove the cover.
☞ Remove the filter.
If the recirculated air filter permalyt is used:
☞ Unplug the connection cable.
97