Run-On Function; Hob Lighting - Berbel BKH 80 ST Manuel D'utilisation

Operation
The active power setting is displayed by the LEDs illuminated
beneath the buttons:
y 1 LED lights up = Power setting 1
y 2 LEDs light up = Power setting 2
y 3 LEDs light up = Power setting 3
To achieve an optimal efficiency in removing cooking fumes:
☞ Turn the device on 1-2 minutes before you start cooking.
This allows the flow of air to build up, and the fumes are
removed at an early stage.
☞ In order to collect the cooking fumes effectively, use the
rear hob plates for intensive cooking.
☞ During the cooking process, switch to a power level that
is appropriate for the intensity of the cooking vapours:
y Power level 1 - lowest fan power
y Power level 2 - medium fan power
y Power level 3 - high fan power
☞ If the intensity of the cooking vapours does not subside,
switch to a higher power level.
☞ Switch to power setting 3 if frying.
☞ Turn on the run-on function when you have finished
cooking.
D "4.3.1 Run-on function" (page 105).
☞ Check the fresh air supply at regular intervals.
☞ Use the device also to reduce other unpleasant smells.
Such as from:
y Onions and garlic
y Oven, microwave and steamer
y Fondue and raclette
D WARNING
Fire hazard due to grease residue!
In operation grease residue, which is highly inflammable,
collects in and on the device.
☞ Clean the device properly.
D "5. Cleaning" (page 106).
If you switch the machine on and hear an unusually loud fan
noise:
☞ Clean the device.
☞ Observe the stipulations for cleaning.
D "5. Cleaning" (page 106).
If you switch the machine on and notice a smell:
☞ Change the filter filling.
☞ Observe the stipulations for changing the filter filling.
D "6.2.1 Replacing filter filling" (page 108).
After 6 hours without operation, the device (including
lighting) automatically switches off.
6003417_a – 26.09.2017
4.3.1

Run-on function

The device comes with a run-on function. If this function is
used, the device will work for a further 10 minutes at power
setting 2.
In recirculated air mode, it is necessary to use the run-on
function so that the device can remove the remaining
odours. Using the run-on function increases the life of the
filter filling. The filter filling must be replaced at regular
intervals.
Button Function
The device is turned off.
☞ Press button 1x.
The device switches on the run-on function
with power setting 2.
The run-on function is switched on.
☞ Press button 1x.
The run-on time starts again (10 minutes).
When the power stage changes, the run-on
function is ended.
During the run-on time (10 minutes), the LEDs
for power settings 1 and 2 will flash.
4.3.2

Hob lighting

The hob lighting is fitted with energy-saving LED lighting.
The lighting can be used at any time and independently of
the fan.
Button Function
☞ Press button 1x, in order to switch the hob
lighting on or off.
105