Hella KLX Instructions De Montage page 12

Page 4 Fitting the light dome
Fit the light dome by turning it until it
is tight, so as to achieve a seal. Make
sure that the seal is seated correctly.
Do not forget the securing screw.
Page 5 Electrical connection
(fuse-protected positive cable)
Use a minimum cable cross-section
2
of 1.5 mm .
Page 6
Replacing the flash tubes
Be careful, the flash tube is hot after
operation.
13
CAUTION!
Before opening the light dome,
switch off the voltage supply
and wait for at least one minute
(for the capacitor to discharge).
Spare parts
Technical data
Operating voltage range:
Total current consumption:
1) Undo the screw connection on the
light dome, remove the light dome.
2) Screw the cover off.
3) Remove the faulty flash tube and
replace it.
Screw the flashing beacon back
together in the reverse order of
disassembly.
• Flash tube
• Rubber base, wedge-shaped
Flash energy:
Flashing sequence: double-flash
Flashing frequency: 2 Hz
10 - 15 V (12 V)
Interference
20 - 30 V (24 V)
suppression:
12 V -> 3.3 A
24 V -> 1.7 A
Another tip:
Keep the light dome clean. Dirt
an absorb up to 80 % of the light
output.
Do you have spare bulbs and fuses
in your vehicle?
If you have questions or installation
problems please contact Hella
customer service.
• PCB replacement set 24 V
• PCB replacement set 12 V
10 Ws + 2 Ws Temperature range:
Fine-wire fuse:
Reverse polarity protection: yes
e1 approval in accordance
Light dome:
with 72/245 EC, Housing:
version 94/95 EC
40°C to +60°C
12 V -> 10 A
24 V -> 7,5 A
polycarbonate
PBT+PC-GF20