Water Outlet Hose; Electrical Connection; Prior To Using The Machine - BORETTI BVW-682 Notice D'emploi

available), the water can be drained directly
into the sink via hooking the bent pipe over the
edge of the sink. This connection should be at
a minimum of 50 cm and and at a maximum of
110 cm from the fl oor plane.
Warning: When a drain hose longer than 4 m
is used, the dishes might remain dirty. In that
case, our company will not accept responsibil-
ity.
42
Water outlet
hose
The water drain
hose can be
connected ei-
ther directly to
the water drain
hole or to the
sink outlet spig-
ot. Using a spe-
cial bent pipe (if

Electrical connection

The earthed plug of your machine should be
connected to an earthed outlet supplied by
suitable voltage and current. If there is no
earthing installation, have a competent electri-
cian carry out an earthing installation. In case
of usage without earthing installed, our compa-
ny will not be responsible for any loss of usage
that might occur.
The indoor fuse current value should be
10-16 A. Your machine is set according to 220-
240 V. If the mains voltage in your location is
110 V, connect a transformer of 110/220 V
and 3000 W inbetween. The machine should
not be plugged in during positioning.
Always use the coated plug supplied with your
machine.
The machine's electrical cable should be re-
placed by an authorised service or an author-
ised electrician only. Failure to do so may lead
to accidents.
In order not to cause an electric shock, do not
unplug when your hands are wet.
For safety purposes, always make sure to dis-
connect the plug when a wash programme is
fi nished.
Running in low voltage will cause a decline in
washing quality.
When disconnecting your machine from the
mains supply, always pull from the plug. Never
pull the cord itself.
Prior to using the machine for the fi rst time
• Check whether the electricity and supply
water specifi cations match the values indi-
cated by the installation instructions for the
machine.
• Remove all packaging materials inside the
machine.
• Set the water softener.
• Add 2 kg salt into the salt compartment and
fi ll with water up to a level at which it will
almost overfl ow.
• Fill the rinse aid compartment.