Spray Arms; Hose Filter - BORETTI BVW-682 Notice D'emploi

Spray arms

Check whether or not the holes for the upper
and lower spray arms are clogged. If there is
any clogging, remove the spray arms and clean
them under water.
You can remove the lower spray arm by pulling
it upwards, while the upper spray arm nut can
be removed by turning the nut to the left.
Be sure that the nut is perfectly tightened
when refi tting the upper spray arm.
Hose fi lter
Water is prevented by the inlet hose fi lter so as
to avoid any damage to your machine because
of any contamination (sand, clay, rust etc.)
that might be occasionally carried in through
the mains water supply or the indoor plumbing,
and to forestall such complaints as yellowing
and formation of deposits after washing. Check
the fi lter and the hose from time to time and
clean them if necessary. To clean the fi lter, fi rst
turn off your tap and then remove the hose.
After removing the fi lter from the hose, clean
it under the tap. Insert the cleaned fi lter back
into its place inside the hose. Refi t the hose.
DE
EN
65