Installing The Machine; Positioning The Machine; Water Connections; Water Inlet Hose - BORETTI BVW-682 Notice D'emploi

Installing the machine

Positioning the machine

When determining the place to put your ma-
chine on, take care to choose a place where you
can easily load and unload your dishes.
Do not put your machine in any location where
there is the probability for the room tempera-
ture to fall below 0°C.
Before positioning, take the machine out of its
packaging by following the warnings located on
the package.
Position the machine close to a water tap or
drain. You need to site your machine, taking
into consideration that its connections will not
be altered once they are made.
Do not grip the machine by its door or panel in
order to move it.
Make sure that the water inlet and outlet hos-
es do not get squeezed while positioning the
machine.
Also, make sure that the machine does not
stand on the electrical cable.
Adjust the machine's adjustable feet so that it
can stand level and balanced. Proper position-
ing of the machine ensures problem-free open-
ing and closing of its door.
If the door of you machine does not close prop-
erly, check if the machine is stable on the fl oor
it stands; if not, adjust the adjustable feet and
ensure its stable position.
Water connection
Be sure that the indoor plumbing is suitable for
installing a dishwasher. Also, we recommend
that you fi t a fi lter at the entrance of your place
or apartment so as to avoid any damage to
your machine because of any contamination
(sand, clay, rust etc.) that might be occasion-
ally carried in through the mains water supply
or the indoor plumbing, and to forestall such
complaints as yellowing and formation of de-
posits after washing.

Water inlet hose

before making the connection. Connect the
water inlet hose directly to the water inlet
tap. The pressure supplied by the tap should
be at a minimum of 0.03 Mpa and and at a
maximum of 1 Mpa. If the water pressure is
above 1 Mpa, a pressure-relief valve should
be fi tted inbetween. After the connections are
made, the tap should be turned on fully and
checked for water tightness. For the safety of
your machine, make sure to always turn off the
water inlet tap after each wash programme is
fi nished.
NOTE: Aquastop water spout is used in some
models. In case of using Aquastop, a danger-
Do not use the water
inlet hose of your old
machine, if any. Use
the new water inlet
hose supplied with your
machine instead. If you
are going to connect a
new or long-unused wa-
ter inlet hose to your
machine, run water
through it for a while
ous tension
exists. Do not
cut Aquastop
water spout.
Do not let it
get folded or
twisted.
DE
EN
41