Filling With Rinse Aid And Making The Setting - BORETTI BVW-682 Notice D'emploi

• They produce good results for certain types
of usage only. If you are using this type of
detergents, you need to contact the manu-
facturers and fi nd out about the suitable con-
ditions of use.
• When the conditions of use of such products
and the machine settings are appropriate,
they ensure savings in salt and/or rinse aid
consumption.
• Contact the detergent manufacturers if you
are not obtaining good wash results (if your
dishes stay calcareous and wet) after having
used 2 in 1 or 3 in 1 detergents. The scope
of warranty for your machine does not cover
any complaints caused by the use of these
types of detergents.
Recommended usage: If you are using a com-
bined detergent, then add rinse agent into your
machine ,switch the rinse agent settings into
its lowest (1) position and active the tablet
detergent button in order to obtain better re-
sults.If the water hardness level is above level
4, then it is necessary to fi ll in the salt con-
tainer with salt.t is not recommended to use
combined detergents in fast programs.
Warning: Should any problem, which you have
not encountered before, arise with the use of
this type of detergents, contact the detergent
manufacturers directly.
When you give up using combined detergents
• Fill the salt and rinse aid compartments.
• Adjust the water hardness setting to the
highest position and run an empty-wash.
• Adjust the water hardness level.
• Make the suitable rinse aid setting.

Filling with rinse aid and making the setting

Rinse aid is used to prevent the stay of white
water drops, lime stains, white fi lm strip-
shaped stains that may form on the dishes,
as well as to increase the drying performance.
Contrary to the popular beliefs, it is used not
50
only for obtaining shinier dishes but also for
obtaining suffi ciently dried dishes. For this
reason, care should be taken that there is ad-
equate amount of rinse aid in the rinse aid com-
partment and only polishing material produced
for use at dishwashers should be used.
compartment cap by turning it. 1 Fill the rinse
aid compartment with rinse aid until the rinse
aid level indicator becomes dark; 2 refi t the cap
dispenser, you can understand whether or not
your machine needs rinse aid.
A dark indicator b means that there is rinse
aid in the compartment, while a light indicator
a shows that you need to fi ll the compartment
with rinse aid.
The rinse aid level adjuster can be set to a posi-
tion between 1 and 6. Factory setting for rinse
aid is the position 3. You need to increase the
degree of the adjuster if water stains form on
If the rinse aid lamp
on the control panel
becomes on fi ll the
rinse aid compart-
ment with rinse.
To put rinse aid, re-
move the rinse aid
and close it by turn-
ing it in a way that
the nails will corre-
spond to one anoth-
er. By checking the
rinse aid level indica-
tor on the detergent
your dishes after a
wash, whereas you
need to decrease
the degree if a blue
stain is left when
wiped by hand. 3