First Use; Setting The Water Softener - BORETTI BVW 96 Notice D'utilisation

return to setting mode, the programme has
to be cancelled.
To cancel a programme in progress
• Simultaneously press and hold the two
function buttons B and C until all the pro-
gramme button lights come on. The pro-
gramme has been cancelled and the ap-
pliance is now in setting mode.
Audible signals
Audible signals help to indicate which oper-
ations the appliance is performing:
– adjustment of the water softener,
– end of the washing programme,
– intervention of an alarm due to malfunction
of the machine.
Factory setting: audible signals active
It is possible to deactivate the audible
signals.
Deactivation/activation of the audible signals
1. Press the on/off button. The appliance
must be in setting mode.

First use

Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level

Setting the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
Water hardness
°dH
51 - 70 91 - 125
43 - 50
°TH mmol/l
9,1 - 12,5
76 - 90 7,6 - 9,0
2. Simultaneously press and hold function
buttons B and C until the lights of function
buttons A, B and C start flashing.
3. Press function button C,
– The lights of function buttons A and B
go off,
– the light of function button C goes on
flashing,
– at the same time the end of pro-
gramme indicator light comes on.
The audible signals are active.
4. To deactivate the audible signals:
– press function button C,
– the end of programme indicator light
goes off.
The audible signals are deactivated.
5. To memorize the operation, switch off the
appliance.
To activate again the audible signals fol-
low the above operations until the end of
programme indicator light comes on.
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. set the multitab function. (Re-
fer to 'Multitab function').
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Adjusting the water hardness setting
manually
2
2
Use of
electronically
level 10
level 9
75
salt
yes
yes