Failure codes and what to do in case
of failure
ERROR CODE
ERROR DESCRIPTION
F5
Inadequate water supply
F3
Error of continuous water input • Close the tap.
F2
The waste water in the
machine cannot be discharged.
F8
Heater error
F1
Alarm is active against water
overflow
FE
Faulty electronic card
F7
Overheating error (tempera-
ture in the machine is too high)
F9
Divisor position error
F6
Faulty heater sensor
If the programme won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine
door.
• Be sure that you switched off the machine by
pressing the Power On / Off button.
• Be sure that the water inlet filter and the
machine filters are not clogged.
If detergent residues are left in the detergent
compartment
Detergent has been added when the detergent
compartment was wet.
66
CONTROL
• Make sure the water input tap is totally open and that
there is no water cut.
• Close the water input tap, separate the water input
hose from the tap and clean the filter at the connection
end of the hose.
• Restart your machine, contact the service if the error
resumes.
• Contact the service.
• Water discharge hose is clogged.
• The filters of your machine might be clogged.
• Power off-on your machine and activate the program
cancellation command.
• If the error continues, contact the service.
Contact the service.
• Power off your machine and close the tap.
• Contact the service.
• Contact the service.
• Contact the service.
• Contact the service.
• Contact the service.
If water is left inside the machine at the end of
the programme
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The programme is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a
wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.