BORETTI BVW-682 Notice D'emploi page 137

If there are partial food wastes left on the
dishes
• Dishes placed incorrectly into the machine,
sprayed water did not reach related places.
• Basket overly loaded.
• Dishes leaning against one another.
• Very small amount of detergent added.
• An unsuitable, rather weak wash programme
selected.
• Spray arm clogged with food wastes.
• Filters clogged.
• Filters incorrectly fitted.
• Water drain pump clogged.
If there are whitish stains on the dishes
• A very small amount of detergent is being
used.
• Rinse aid dosage setting at a very low level.
• No special salt is being used despite the high
degree of water hardness.
• Water softener system setting is at a very
low level.
• Salt compartment cap not closed well.
• A detergent without phospate used; try one
that contains phosphate.
If the dishes won't dry up
• A programme without a dry operation
selected.
• Rinse aid dosage set too low
• Dishes unloaded too fast.
If there are rust stains on the dishes
• Stainless-steel quality of the dishes washed
is insufficient.
• High rate of salt in the wash water.
• Salt compartment cap not closed well.
• Too much salt spilt into the sides and into the
machine while filling it with salt.
• Unhealthy mains grounding.
Door is not opened / closed properly;
• Not proper weight wooden part inserted
on the door. (Follow the weight given in the
Assembly manuel)
• The tensile of the door spring not adjusted
properly. Adjust it according to the Assembly
manuel.
Call an authorised service if the problem still
persists after the controls or in case of any
malfunction not described above.
DE
EN
67