Sideguards - Sunrise Medical SOPUR Helium Notice D'utilisation

Sideguards

Single Post Height-Adjustable Armrests
(Fig. 4.29 - 4.32).
1. Assembly
a. slide the outer armpost into the receiver mounted to the
wheelchair frame.
b. the armrest will automatically lock into place.
2. Height adjustment
a. rotate height release lever (2) to second stop.
b. slide armrest pad up or down to desired height.
c. return lever to locked position against arm post.
d. push arm pad (4) until upper arm post locks firmly into
place.
3. Removing the armrest
a. pull lever 3 and lift entire arm.
4. Replacing Armrest
a. slide armrest back into receiver until arm latches in place.
Armrest Receiver Attachment
(Fig. 4.29 - 4.32).
Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
1. Loosen the four receiver adjustment bolts (9) on the sides of
the receiver.
2. With the armrest in the receiver (7), squeeze the receiver to
achieve the desired fit.
3. Tighten the four bolts (9). (16.3 Nm)
Position Adjustment
1. Loosen the two clamp bolts (10) until clamp is loose.
2. Slide armrest receiver to desired position.
3. Tighten
4
Fig. 4.29
5
6
2
1
9
7
3
Fig. 4.31
9
42
Fig. 4.30
7
8
9
10
9
10
Fig. 4.32
7
Central support
Installation: Slide the arm post into the receiver, located on the
wheelchair frame, until it stops
Height adjustment:
Slide the armrest post out of the receiver.
Adjust the position of the height adjustment bracket (1) by
removing the screw (2) and moving it to the desired position.
Re-fit the screw and tighten it.
Slide the arm rest post back into the receiver, (Fig. 4.32.1).
Armpad Position:
The armpad position can be adjusted by releasing the screws
(3), then moving the arm pad to the desired position. Re-tighten
the screws, (Fig. 4.32.1).
Adjusting Armrest Receiver
The tightness of the armrest receiver can be adjusted (tightened
/loosened) by means of the 2 screws (1) - (Fig. 4.32.2).
Fig. 4.32.1
3
1
2
Fig. 4.25 - 4.28 Parts key
1. Outer armpost
2. Height Release Lever
3. Release lever
4. Armrest Pad
5. Transfer bar
6. Sideguard
7. Receiver
8. Clamp
9. Receiver adjustment bolts
10. Clamp bolts
Fig. 4.32.2
1
Helium Rev.I