Making Preparations - Mesto PICO 3232 Mode D'emploi

GB IRL

Making preparations

Observe the instructions in the section entitled „Safety".
The device must be in an upright position.
into the tank.
1. Pull up the red piston pressure gauge handle [14] until the tank is depressurized.
2. Unscrew the pump [2] from the tank.
If used for HERBICIDES, this spraying device should no longer be used for
applying pesticides.
3. Add the spraying liquid to the tank [1]
5. Screw the pump [2] into the tank.
6. Press the piston rod with handle [16] down and turn it clockwise.
7. Create the desired pressure
8. Press the piston rod with handle [16] down and turn it clockwise.
Spraying
Observe the instructions in the section entitled „Safety".
Operate the device only while it is vertical or suspended upright and nearly
vertical.
Avoid allowing drops of spray to drift onto areas that are not being treated.
Observe the instructions of the spray product manufacturer!
1. Hang the device over your shoulder.
2. Activate the shut-off valve [7]
gauge [14]
Spraying pressure
1.5 bar
2.0 bar
3.0 bar
Table 2. Dependence: spraying rate and spraying pressure
4. If the spraying pressure decreases more than 0.5 bar from the optimum level, pump
some more.
AUS
.
Spray quantity for hollow cone nozzle
USA NZ
)
)
in the tank
0.49 l/min (0.13 gal/min)
0.56 l/min (0.15 gal/min)
0.69 l/min (0.18 gal/min)
16
CDN IND