Ingerev Garage Wall / Garage One - Ingeteam INGEREV GARAGE Basic GB120-C1 Manuel D'installation Et Usage

Ingeteam
3. Connect the vehicle to the charging station.
Ending the charging process (with a card reader)
To finish the charge cycle identify the card using the reader. The front LEDs flash yellow when waiting for a vehicle
to be disconnected. Remove the connector from the vehicle.
The station will return to the awaiting vehicle status.

9.2.2. INGEREV GARAGE Wall / GARAGE One

The electrical supply connector must not be removed from the vehicle while the charging is being
carried out.
Immediate charge
When choosing this option, the charge begins when the vehicle is connected to the station.
32
This station has a display+keypad set for the purpose of accessing the
different menus of its firmware.
The following points indicate the procedures that must be carried out to
start and end the charging process.
There are two options in order to carry out the charge:
• Immediate charge.
• Deferred charge (in order to use this option it must be enabled
in the station).
The charging process is slightly different depending on the charging
process selected.
Carefully read this information and in the event of any doubt contact the
Ingeteam Customer Service.
ABA2021IQM01_A - Installation and Operation Manual
Operation