Hang The Charger From The Bushing; Fix The Charger To The Wall; Supply Power To The Charger; Installation Of The Curve Device - Ingeteam NEO Pro Manuel D'installation Et Usage

Ingeteam

3.1.9. Hang the charger from the bushing

Hang the charger on the upper screw bushing.
FRONTAL

3.1.10. Fix the charger to the wall

1. Fit the three screws on the lower part of the charger and tighten them firmly.
2. Fit the caps to cover the three screws.

3.1.11. Supply power to the charger

Close the cut-off element of the electrical circuit that powers the charger.

3.2. Installation of the CURVE device

CAUTION
The CURVE device is designed to be used with the NEO Pro charger (single-phase).
14
1
2
Wall mounting: 4.8x90 screw
STAND assembly: M5x70 screw
ABV2012IQM01_ - Installation and Operation Manual
Installation