Ingeteam INGEREV GARAGE Basic GB120-C1 Manuel D'installation Et Usage page 34

Ingeteam
Connector type
IEC 62196-2 Type 2
IEC 62196-2 Type 3A
The INGEREV GARAGE Wall station does not allow, nor is it designed for simultaneous use of both
sockets. Only the selected socked is enabled.
5. When the vehicle is connected to the station the following screen is shown indicating that the charging
process has started correctly.
Ending the charge process
6. To finish the charge cycle identify the card using the reader. The station interrupts the electric supply and
unblocks the mode 3 and type 2 connector if one of them has been used.
7. Pull out the connector.
The station will return to the awaiting vehicle status.
Deferred charge
For paired charge points the option to defer the charge process is possible. In order to be able to select this type of
charge the station must have the deferred charge option enabled.
The time selected to start the charge process can be adjusted afterwards by the user.
The charge process is the same as the immediate charge, differing in the following points:
Starting the charge process
1. Check that the station is in the awaiting vehicle status, showing the following two screens alternately:
2. Press to access the language selection menu for the charging session. Once the charging process ends
the default language of the station will be enabled.
LANGUAGE LANGUAGE
ENGLISH ENGLISH
34
INGEREV GARAGE Wall
Connection detection
Instant automatic detection
Instant automatic detection
CHARGING CHARGING
After accessing the language selection menu browse
through the options by pressing
Select the required language and press
ABA2021IQM01_A - Installation and Operation Manual
Regulation governing the charge
sequence
IEC61851
IEC61851
or .
.
Operation