Compliance Statements - MIRKA AROS-B 150NV Mode D'emploi

Compliance statements

This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential
installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications However, there is no
guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
NOTE: The user is cautioned that any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s) Operation is subject to the following two conditions:
1 This device may not cause interference
2 This device must accept any interference, including interference that may cause undesired operation of the device
WARNING
• Always wear required personal safety protection in accordance with manufacturer's instructions and local/national
standards while using this tool
• Read the Materials Safety Data Sheet (MSDS) for the work surface
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations
Safety rules for battery pack and charger
WARNING!
• Important safety and operating instructions for your battery and charger Before using the charger, read all
instructions and warnings on the charger, the battery pack and the tool
• If the battery pack casing is cracked or damaged, do not insert into charger There is a danger of electric shock or
electrocution
• Do not allow any liquid to get inside charger Electric shock may result
• This charger is not intended for any uses other than charging rechargeable batteries
• Do not place any object on top of the charger, near any heat source or place the charger on a soft surface that may
result in excessive internal heat
• Make sure the cord is located so it will not be stepped on, tripped over, or otherwise subjected to damage or stress
• Do not use the charger if it has received a sharp blow, been dropped or otherwise damaged in any way
• DO NOT store or use the tool and battery pack in locations where the temperature may reach or exceed 50 °C (122 °F)
• The charger is designed to operate on standard household electrical power (100–240 VAC) Do not attempt to use it
on any other voltage
CAUTION
• Always ensure the work piece to be sanded is firmly fixed in place
• Make sure the abrasive is perfectly centered and firmly attached to the backing pad
• Always pay attention to work safety
• Keep hands clear of the spinning pad during use
• Do not allow the tool to free speed without taking precautions to protect any persons or objects from the loss of the
abrasive or backing pad
Mirka® AROS-B 150NV & AOS-B 130NV • 32 mm (1 ¼") • 10.8 V
en | us • ca
191