Evolution F165 CCSL Notice Originale page 15

www.evolutionpowertools.com
with the blade. The blade and/or motor
could become damaged if the machine is
used with an incorrectly adjusted parallel
edge guide.
• Place front edge of sole plate squarely on
the workpiece. Before starting the motor
ensure that the blade is not in contact with
the workpiece.
• When starting a cut, taking care to introduce
the blade to the material slowly,
so as not to damage blade teeth.
Note: Two (2) line of cut guides are provided at
the front of the sole plate of the CCSL machine
(for 0 and 45 bevel angles only).
0 0
• Use both hands to move the saw forwards
through the work piece.
• Apply smooth, constant pressure to move
the saw forwards through the workpiece.
Note: All CCS series machines have an
automatic lower blade guard which has a
specially shaped leading front edge. This
feature ensures that the blade guard retracts
smoothly and effortlessly as the machines
blade enters the workpiece. As the blade exits
the workpiece the lower blade guard will
automatically return to its normal position
covering the blade completely.
Note: On some occasions e.g. making a
plunge cut into a floor or wall etc it may be
advantageous to retract the lower blade
guard manually.
A thumb operated lever is provided on the
lower blade guard. With care, a skilled operator
can retract the blade guard manually, either
partially or fully, allowing plunge cuts to be
made.
WARNING: If retracting the blade guard
manually great care must be taken to ensure
that the operators hand or fingers do not touch
any part of the machines blade.
When a cut has been completed:
• Release the ON/OFF Trigger switch.
• Allow the blade to come to a
complete stop.
• Remove the machine from the workpiece
allowing the lower blade guard to return to
its normal position covering the blade.
WARNING: If the motor should stop or stall
whilst a cut is being attempted release the
trigger switch immediately. Disconnect the
machine from the power supply and remove
the machine from the workpiece.
Investigate the cause of the problem and
rectify if possible.
Only attempt to restart the motor when you are
absolutely sure that it is safe to do so.
CUT MATERIAL EJECTION PORT
WARNING: Do not use the dust bag and dust
port adaptor when cutting metallic materials
including wood with nails.
MAINTENANCE & ADJUSTMENTS
(18)
CCS series
The 0 (blade vertical) position can be adjusted.
0
WARNING: The machine must be disconnected
from the mains power supply when attempting
this procedure.
To check 0 position:
0
• Set the blade to the 0 position with the
0
tilting mechanism against its stop.
• Check the blade against the sole plate using
an engineers precision square (not supplied).
Take care to avoid the TCT tips of the teeth.
The blade should be at exactly 90
plate.
Note: The lower blade guard should be rotated
(manually) up into the upper blade guard. This
will help accurate positioning of the engineers
square and thus aid the checking process.
If adjustment is required:
Turn the adjustment screw (Fig. 16) clockwise
or counter clockwise using a Hex Key (not
supplied) until the blade is at exactly 90
sole plate.
15
EN
to sole
0
to the
0