Yamaha Harmony Director HD-200 Mode D'emploi page 13

Setting Figure
With this function, you can change the tonal characteristics.
By pressing the [FIGURE] button so that its lamp lights, the three
sliders become available and the settings made via these sliders are
applied to the keyboard sound.
Move the [ATTACK] slider to adjust how long it takes for the sound to
reach full volume when a note is pressed.
Move the [RELEASE] slider to adjust how long it takes for the sound to
decay to silence after a note is released.
Move the [BRILLIANCE] slider to adjust the brilliance of the selected voice.
By pressing the [FIGURE] button so that its lamp goes out, the three
sliders become unavailable and the settings made via these sliders are not applied to the keyboard sound.
Turning Hold On/Off
With this function, notes can be maintained even if your fingers are released from
the keyboard.
Press the [HOLD] button so that its lamp lights. In this state, notes will be
maintained even if your fingers are released from the keyboard. When one or more
notes are being maintained, you can change the maintained notes by pressing other
keys.
Press the [HOLD] button again to exit this state. Turning off this button will stop
the maintained sound.
Selecting Octave
With this function, you can change the keyboard's octave.
Move the [OCTAVE] switch to select the octave.
Switch position and octave
Switch Position
Octave
LOW1 LOW2
C0–C4 C1–C5
* This function is not available when PIANO is selected.
MID HIGH
C2–C6 C3–C7
8