Yamaha Harmony Director HD-200 Mode D'emploi page 20

Tap
With this function, you can set the metronome tempo by tapping a key.
Press the [TAP TEMPO] button so that its lamp lights, then tap the
rightmost white key three times ("Tap2," "Tap1," and "Tap0" are shown in
order) to start the metronome in the tempo calculated by averaging the
intervals between the three taps.
When the metronome is stopped, the above operation will start the
metronome. When the metronome is running, the above operation will
change the playback tempo.
Press the [TAP TEMPO] button again to return the keyboard to its normal
state.
Note
When the TAP indicator is turned on, press the [A], [B
keyboard to trigger the sound of claves, side stick, and cowbell, respectively.
Memory
With this function, you can save up to eight metronome settings ("M1"–
"M8"). Each of them can be called up via a single touch.
Press the [MEMORY] button so that its lamp lights, then select the Memory
number ("M1"–"M8") by using the DATA ENTRY dial or [+]/[-] buttons.
After settings for the current Memory number are completed, select another
number to make settings for if necessary.
When the [MEMORY] lamp is turned on, you can select the Memory
number ("M1"–"M8") by pressing the key corresponding to "M1"–"M8"
printed on the top panel above the keyboard.
15
4
4>
b
] and [B] key on the far right side of the
6 3 6 6 2 6 3 9
8 4 8 8 4 8 4 8