Tempo Setting; Beat Setting - Yamaha Harmony Director HD-200 Mode D'emploi

Tempo Setting

On the METRONOME display, you can set the metronome tempo. Press the
[TEMPO] button to move the cursor to the tempo value column, then set the
quarter note tempo by using the DATA ENTRY dial or [+]/[-] buttons.
The tempo range is 32–280. Press the [+] and [-] buttons simultaneously to
reset the tempo value to 120.

Beat Setting

On the METRONOME display, you can set the meter as well as the
metronome tempo. You can also set an irregular meter or multi-metered
beats (e.g., 2/8+2/8+3/8) as well as a normal meter (e.g., only 4/4). You can
create multi-metered beats of up to 8 measures.
To set a normal meter, press the [BEAT] button to move the cursor to the
meter section, then set the numerator and denominator values of the meter
respectively by using the DATA ENTRY dial or [+]/[-] buttons. Use the
CURSOR buttons to move the cursor between the numerator and
denominator.
To set an irregular meter, press the CURSOR [>] button several times to
indicate the meter for the next measure. Set the numerator and denominator
values of the meter respectively by using the DATA ENTRY dial or [+]/[-]
buttons. Perform the same operation for additional measures.
Note
Press the [MEMORY] and [BEAT] buttons simultaneously to reset the beat to 4/4 (1 measure).
Quarter Triplet
The metronome can be played back as quarter triplet by turning on the [QUARTER
TRIPLET] lamp.
When the [QUARTER TRIPLET] button is turned on, you can hear the correct
quarter triplet by setting the meter to 4/4, setting the BEAT VOLUME quarter note
slider to a low level, setting the BEAT VOLUME triple note slider to a higher
level, and setting the other BEAT VOLUME sliders to 0.
4
4>
6 3 6 6 2 6 3 9
8 4 8 8 4 8 4 8
3 3 3
14