Setting Up And Voice Settings; Turning The Power On/Off; Master Volume Control; Selecting A Voice For Tuning - Yamaha Harmony Director HD-200 Mode D'emploi

Setting Up and Voice Settings

Turning the Power On/Off

This instrument will run either from an optional AC power adaptor or batteries.
Make sure that the instrument's [STANDBY/ON] switch is set to STANDBY (off),
then execute the following steps.
When using the AC power adaptor, connect the adaptor's DC plug to the
instrument's DC 12V IN jack on the rear panel, then connect the other end
(standard AC plug) to the nearest electrical outlet.
When using batteries, open the battery compartment cover located on the bottom
panel, insert six new alkaline batteries, then replace the compartment cover,
making sure that it locks firmly in place.
After setting up, press the [STANDBY/ON] switch to turn on the power.
The HARMONY display and METRONOME display show the same information
as the last time the power was turned off.
Because this instrument is equipped with a backup battery, the settings made on this instrument will be
maintained even if the power is turned off.

Master Volume Control

Move the [MASTER VOLUME] slider toward MAX to turn up the volume and
Move the [MASTER VOLUME] slider toward MIN to turn down the volume.

Selecting a Voice for Tuning

This instrument features 10 different voices for tuning. You can select the
desired voice by pressing the corresponding button. The lamp of the
selected button lights.
The best voice for tuning
It may be a good idea to select ORGAN or STRING so that both the teacher and student can
easily recognize the pitch difference between the instrument's sound (played by the student)
and the Harmony Director's sound.
7