Maico EZD 30/ B Série Instructions De Montage Et Mode D'emploi page 17

Fault
Unit doesn't run
Thermal overload
protection
switches the unit
off.
Deposits on the
impeller and in
the housing
caused by dust in
the air.
Impeller not
turning.
11. Spare parts
Spare parts are listed in bold in chapter
3.1. If ordering spare parts, please
provide:
1. Print no. of instructions 0185.0089.0001.
2. Production date, see stamp on
housing [13], e.g. 039208.
3. No. of rating plate [S1] and [S2],
= no. on side of rating plate.
4. Item number in chapter 3.1.
Countermeasure
Check whether the mains
fuse is switched on. If
necessary, also check the
service switch.
Put the on/off switch to the
"off" position.
Let the motor and the
temperature limiter cool
down before switching the
unit back on. It may take
several hours to cool
down. Only switch unit
back on once cool.
If the fault persists, call on
the services of a trained
electrician.
Call on the services of a
trained electrician. Install
an air filter in the ducting.
Under no circumstances
should the inside of the
unit be cleaned with water
or a high-pressure cleaner.
Switch off unit. Ensure that
the impeller is not blocked
by foreign bodies.
12. Dismantling
Danger to life from electric
shock
 Before dismantling, completely
DANGER
disconnect unit from the power
supply or switch the service
switch to the OFF position and
secure against being switched
back on.
 Position a warning notice to
avoid the unit being
accidentally switched back on.
Danger to life from improper
transport!
 Observe information in
DANGER
chapter 6, Transport.
Dismantling should only be carried
i
out by a trained electrician.
13. Disposal
Not in domestic waste.
i
The unit contains in part material that
can be recycled and in part
substances that should not end up as
domestic waste.
 Dispose of the unit once it has reached the
end of its working life according to the
regulations valid where you are.
GB
15