Establishing The Power Supply; Controlling The Volume Flow - Abicor Binzel xFUME FLEX Mode D'emploi

xFUME™ FLEX

6.2 Establishing the power supply

► Note the safety instructions.
 2.6 Safety instructions for the electrical power supply on page EN-7
Electric shock due to defective cables
Damaged or improperly installed cables can lead to fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Damaged, deformed or worn parts should only be replaced by a qualified electrician.
Risk of injury due to fire
Improper use or connection can result in fire. This may result in serious burns.
► Ensure that the operating voltage specified on the nameplate is suitable for the mains voltage.
For the mains voltage and the fuse protection, please refer to:
 4.2 Technical data on page EN-10
 1.2 Nameplate on page EN-3
 13 Circuit diagram on page EN-25
► Plug in the power plug.

6.3 Controlling the volume flow

A lever on the extraction hood can be used to manually control the volume flow. When the lever is vertical,
the valve is open and the extracted welding fumes flow unimpeded. If the lever is horizontal, the valve closes
and limits the volume flow of the extracted welding fumes.
Fig. 4
A Valve
WARNING
WARNING
Controlling the volume flow
A
B
6 Commissioning
B Lever
A
B
EN - 15