Decommissioning - Abicor Binzel xFUME FLEX Mode D'emploi

xFUME™ FLEX
Fig. 5
A Extraction arm
B Handle
C Service door
D <On/Off> switch
H
G
F
Adjust the extraction arm (A) to accommodate the work task.
1
Adjust the extraction hood (F) to accommodate the work task. The extraction hood (F) must be located
2
approx. 20 cm above the welding point during operation.
Establish an electrical connection.
3
Switch on the LED light (G) on the extraction hood (F).
4
Adjust air volume to the work task.
5
 6.3 Controlling the volume flow on page EN-15
► Set the <On/Off> switch (D) to <I>.

8 Decommissioning

Set the <On/Off> switch (D) to <O>.
1
Disconnect the device from the power supply.
2
Assembly and use
8 Decommissioning
E 4× castors
F Extraction hood
G LED light
H Light switch
A
B
C
D
E
EN - 17