Replacing The Primary Filter - Abicor Binzel xFUME FLEX Mode D'emploi

9 Maintenance and cleaning

9.3 Replacing the primary filter

The primary filter cannot be cleaned; it must be completely replaced.
Cleaning the primary filter with compressed air or a hammer is not permitted.
EN - 20
Insert the pre-filter.
9
Close the service door and lock it using a square
10
wrench.
Set the <On/Off> switch to <O>.
1
 Fig. 2 Assembly and use on page EN-9
Pull out the mains plug.
2
Unlock and open the service door using a square
3
wrench.
Remove the primary filter.
4
Dispose of the primary filter in accordance with
5
local regulations.
 12 Disposal on page EN-24
Insert the primary filter.
6
Close the service door and lock it using a square
7
wrench.
xFUME™ FLEX