Hofmann geodyna 8250p Mode D'emploi page 104

3
104
5-48
4
4-11
4-12
Operation "MANUAL MODE"
5.14.1 Saving a Wheel Profile
Up to 9 wheel profiles can be saved.
 Clamp the wheel you wish to save the profile of.
 Set and acquire all the wheel data, including the
number of spokes if an Alu P is required.
 In the RIM DATA ENTRY screen press the
"PROFILES" key (Fig. 5-48).
The WHEEL PROFILES screen is displayed (Fig.
4-11).
The current wheel profile data are highlighted in a line
on its own at the bottom of the page.
 In the 9 position list, use the Scroll command to
choose the current profile registration position.
 Press key (3, Fig. 4-11) to save data.
The data are now saved permanently in the chosen
position and can be recalled when required.
Note: If the profile is overwritten with other data it is
no longer shown in the list.
5.14.2 Recalling a Wheel Profile from the
memory
 Clamp the wheel to the balancer.
 In the RIM DATA ENTRY screen press the
"PROFILES" key (Fig. 5-48).
The WHEEL PROFILES screen is displayed (Fig.
4-11).
 Type on one of the nine lines to select the profile
indicated for the wheel being processed.
 Press key (4, Fig. 4-11) to apply the selection.
The RIM DATA ENTRY screen will open (Fig. 4-12)
and show the data recalled.
 Check that the settings in the Indications Field and
Status Bar panel are correct.
The machine is now ready to proceed with the

measuring run ( 5.13).