Festool DOMINO XL Guide D'utilisation page 15

– Close the clamp lever for routing height adjust-
ment [1-14] and the clamp lever for angle adjust-
ment [1-12] to avoid unintentional loosening
during operation.
– Adapt the feed rate to the cutter diameter and
material. Work with a constant feed rate
– Only lay the machine aside when the cutter has
come to a complete standstill.
– Always connect the machine to a dust extractor.
For work that generates dust, wear a dust
mask.
Plug it Power Cord
The Power Tool comes equipped with a removable
plug it power cord.
To install the power cord, insert the cord into the in-
let on the tool with the key and keyway aligned, and
twist the black locking ring.
Reverse the procedure to remove the cord.
Risk of injury
Never turn the tool on when the Fence Body is

removed, as this exposes the spinning cutter.
Before turning the tool on, make sure all adjust-

ment handles are locked and the tool is safe to
turn on.
The switch [1-4] is an on/off switch (I = ON, 0 =
OFF).
If an extension cord is required, it must have suffi-
cient cross-section to prevent an excessive drop in
voltage or overheating. An excessive drop in voltage
reduces the output and can lead to failure of the
motor. The table below shows you the correct cord
diameter as a function of the cord length for this
tool.
11
Total Extension Cord
Lenght (feet)
Cable size (AWG)
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. Instead,
use one long one.
 The lower the AWG number, the stronger the
cord.
Dust hazard
Dust can be hazardous to health. Always work

with a dust extractor.
Always read applicable national regulations be-

fore extracting hazardous dust.
At the extractor connector [1-15], a Festool mobile
dust extractor with an extraction hose diameter of
27 mm can be connected.
 Always work with a dust extractor for safety and
quality reasons.
Switch on/off
WARNING
Extension Cord
25 50
18 16
Dust extraction
WARNING
100 150
16 14
15