Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Switch on/off
Pressing the lever [3-1] switches on the com-
pressed-air tool. Releasing the lever switches the
machine off again.
3-1
3
CAUTION
Risk of injury
The machine should always be disconnected
from the compressed air supply before any work
is carried out on the machine.
Electronics
Speed adjustment
You can regulate the rotational speed steplessly be-
tween 4000 - 7000 rpm using the adjusting wheel
[3-2].
This enables you to optimise the cutting speed to
suit the material.
Attaching sanding accessories
You can choose between 2 types of abrasive fasten-
ing for the compressed-air orbital sander:
Clamping abrasive
Start at the rear.
Open the clamping device [4-1] by pressing the
locking lever.
3-2
Settings
Insert abrasive up to stop [4-2] and release le-
ver.
Then apply abrasive onto sanding pad, pull tight
and clamp with the front lever.
4
Fasten abrasive with StickFix
The suitable StickFix sandpaper and StickFix sand-
ing cloth can be attached quickly and simply to the
StickFix sanding pad.
Press the self-adhesive sanding accessory onto
the sanding pad .
4-1
4-2
9
Publicité
Chapitres
Table des Matières
