Functional Description; Electronics; Settings; Initial Operation - Festool DOMINO XL Guide D'utilisation

The pictures for the functional description are on a
fold-out page at the beginning of the instruction
manual. When reading of the manual you can fold
out this page for having always an overview of the
machine.
[1-1] Rubber buffer
[1-2] Stop pins
[1-3] Handles
[1-4]
On/Off switch
[1-5] Display for dowel hole width
[1-6]
Adjusting lever for dowel hole width
[1-7] Slide for routing depth adjustment
The machine features full-wave electronics with
the following features:
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through elec-
tronic control to ensure a uniform cutting speed
even when under load.
Temperature cut-out
The machine power supply is limited and the speed
reduced if the motor exceeds a certain tempera-
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-

er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with

the voltage specifications 120 V/60 Hz may be
used.

Functional description

[1-8]
[1-9]
[1-10] Unlocking of motor unit/guide frame
[1-11] Selection slide for routing height adjust-
[1-12] Clamp lever for routing angle adjustment
[1-13] Button for releasing stop pins
[1-14] Clamp lever for routing height adjustment
[1-15] Extractor connector
[1-16] Spindle lock
[1-17] Mains power cable

Electronics

ture. The machine continues operating at reduced
power to allow the ventilator to cool the motor
quickly. If the machine temperature exceeds the
maximum permitted value for longer periods, the
machine switches off completely after approx. 40
seconds and can only be switched on again once the
motor has cooled sufficiently.
Restart protection
The integral restart protection prevents the ma-
chine from automatically starting up again after an
interruption in power when the machine is used in
continuous operating mode. In this case the ma-
chine must be switched off and then switched back
on again.

Settings

Risk of injury, electric shock
Always pull the mains plug out of the socket be-

fore performing any type of work on the ma-
chine!
With the joiner unplugged, inspect the mortis-

ing bit. Make sure it is not bent, chipped, or oth-
erwise damaged, and make sure the bit is fully
Snap button for routing depth adjustment
Marker for routing depth adjustment
ment

Initial operation

WARNING
9