Setting The Fence Height - Festool DOMINO XL Guide D'utilisation

tightened on the spindle (Refer to "Settings
Changing tools").
WARNING
Mortising bits that are bent or damaged should no
longer be used.
Risk of injury
Check regularly whether the mortising bit is in

good condition.
Peel off the protective film [2-1] from the bot-

tom of the joiner baseplate.
Remove the transport safety device [2-2].

2-2
10
- Set up the joiner for the appropriate type of op-

eration as described throughout the remainder
of this section.
Make sure that the fence height and angle lock-

ing levers are properly tightened.
Install the power cord into the Plug-It recepta-

cle on the joiner (Refer to "Operation - Plug it
Power Cord").
Setting the Fence Angle
3
2
3-1
3-2
2-1
Some joints require the fence to be set to an angle
from the mortising bit. The most common applica-
tion is for making a mitered joint.
Unplug the joiner for saftey.

Loosen the clamp lever for the angle adjust-

ment [3-1].
Set the desired angle:

using the scale [3-2] variable from 0° to 90°.

locking at 0°; 22.5°; 45°; 67.5°; 90°.

Close the clamp lever [3-1].

Set the routing height and depth as low as
possible when mitre routing as otherwise
there is a risk that the cutter will come out
the other side.
 The alignment of the clamp lever [3-1] can be
aligned by raising the levers. When tightened,
the levers should not protrude beyond the con-
tact surface.

Setting the Fence Height

The height of the fence needs to be adjusted de-
pending on the type of joint being made and the
thickness of the material being joined. The height h