Settings; Tool Holder, Attachments; Working With The Machine - Festool C 12 Li Notice D'utilisation D'origine

C 12 Li, C 15 Li
GB
6.3 Charger wall mount
The charger TRC 3 has two elongated holes
on its back. It can be mounted on a wall us-
ing two screws (e.g. round head or flat head
screw with shank diameter of 5 mm) (see
Fig. [3]).
7

Settings

7.1 Changing direction of rotation
[1-8]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise ro-
tation
7.2 Changing gear
L Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
7.3 Fastening
Adjust the switch so that
faces the screw [1-6]
can be adjusted in this position.
L The switch-over function only works if the
machine is switched off.
X
Adjust the torque accordingly at the
torque [1-1] wheel:
Position 1 = low torque
Position 25 = high torque
The machine switches off when the preset
torque is reached and an acoustic signal
sounds. The machine only continues running
when the on/off switch is
then pressed again.
7.4 Drilling
Adjust the switch [1-7]
faces the drilling symbol [1-5]. Maximum
torque is set in this position.
8

Tool holder, attachments

WARNING
Risk of injury, electric shock
X Always disconnect the battery pack before
any type of work on the machine!
16
[1-4]
[1-7] its marking
symbol. The torque
[1-9] released and
so that its marking
8.1 Tool chuck CENTROTEC WH-CE
[4]
The tool chuck CENTROTEC WH-CE allows
you to change tools with a CENTROTEC
shank in a matter of seconds.
L Always use a CENTROTEC tool chuck to
clamp CENTROTEC tools.
CAUTION
Tool has sharp edges and can cause cut-
ting injuries during a tool change.
X Wear protective gloves!
8.2 Chuck BF-FX
The chuck BF-FX is used for clamping drill
and screwdriver bits.
CAUTION
Risk of injury
X
Clamp the tool centrally in the chuck!
8.3 Angle attachment DD-AS
The angle attachment DD-AS (in part, addi-
tional equipment) permits drilling and screw-
driving at a right angle to the machine.
8.4 Eccentric attachment DD-ES
The eccentric attachment (in part, additional
equipment) permits screwdriving near edges
with bits according to DIN 3126.
8.5 Tool holder in the drill spindle
[8]
Bits can be inserted directly in the hexagon
socket holder on the drill spindle to shorten
and reduce the weight of the machine.
9

Working with the machine

9.1 On/Off switch
Press = ON, release = OFF
L The speed of the machine depends on
how far the on/off switch is pressed in.
The LED lamp [1-3]
switch [1-9] is pressed
working area.
9.2 Bit store [1-2]
The magnetic bit store is designed for hold-
ing bits or bit holders.
9.3 Acoustic warning signal
Acoustic warning signals sound and the ma-
chine switches off in the following operating
states:
[5].
[6]
[1-9]
lights up when the on/off
and lights up the
[7]