Working With The Electric Power Tool; Warning Signals - Festool TPC 18/4 Notice D'utilisation

DC UNI FF
klick
2
1
3
A
4
B
12-1

12 Warning signals

Warning signals occur and the power tool switches off in the following operating states:
11 Working with the electric
12
power tool
Risk of injury
► Only position the power tool on the screw
when it is switched off.
► Always secure the workpiece in such a
manner that it cannot move during ma­
chining.
► Keep hands away from the rotating tools.
Risk of burns
The tool holder and tool may become very
hot during operation.
► Allow them to cool down before attaching
them to the belt clip.
11.1 Kickback stop
Risk of injury
The kickback stop does not guarantee com­
plete protection against a kickback.
► Always concentrate on your work and refer
to the safety instructions and warnings.
The kickback stop is triggered if the tool
is jammed, causing the power tool to
rotate around the screw axis suddenly
and unexpectedly. The power tool switches off,
beeps once and the LED light flashes continu­
ously.
After the kickback stop has been triggered:
► Release the on/off switch [1-5].
► Eliminate the cause of the jam.
► Press the on/off switch again.
11.2 Bit store [1-14]
Risk of injury from metal cuttings in the bit
store.
► Clean the bit store regularly and clear out
metal cuttings.
Magnetic, for storing bits and bit holders.
WARNING
CAUTION
WARNING
CAUTION
English
15