Pump Up Bicycles / Vehicle Tyres; Cleaning And Maintenance; Disposal - Parkside PDZ 25 A1 Instructions D'utilisation Et Consignes De Sécurité

(C) To break the connection, pull the sleeve of the
quick coupling back and pull the quick
2
plug nipple or
3
off the compressor when you do not wish to
use it anymore.
Blow gun
Connect the blow gun
nipple .
4
Connect the blow gun to the compressed air
source (see section „Connect with compressor").
For your own safety, a permanent hose con-
nection between the blow gun
pneumatic hose
1
Screw the rubber nozzle
gun . To be able to screw in the conical noz-
5
zle and the ball needle
8
to unscrew the safety nozzle
blow gun first.
5
Connect the pneumatic hose
pressed air supply and turn it on.
Press the compressed air supply trigger to release
compressed air. The longer you hold down the
trigger, the greater the compressed air output.
Let go of the trigger to stop the compressed air.
Disconnect the product fully from the com-
pressed air supply when you have finished
work.
Pump up bicycles /
vehicle tyres
Depending on the structure of your inflation
valve you can use the pneumatic chuck
the tyre chuck to pump up bicycle or vehicle
15
tyres. To do this you must use a compressed
air gun with a pressure gauge (not included in
delivery).
Connect the pneumatic chuck
chuck with the double coupling
15
connect the other side of the double coupling
with the compressed air gun.
Then connect the compressed air gun with the
pneumatic hose
1
pressure gauge and use the gun to let in the
correct pressure.
out. Remember to turn
4
with a quick plug
5
and the
5
is not recommended.
onto the blow
9
, you have
14
from the
11
with a com-
1
7
or the tyre
7
, then
12
. You can now read the
You can press the tyre gauge
inflation valve to test the inner pressure of the
tyre.
Note: the plug adapter
pling are spare parts that you can use with
13
your own pneumatic tools.

Cleaning and maintenance

Regularly lubricate and clean the product to ensure
proper functionality.
RISK OF INJURY! Disconnect the product fully
from the compressed air supply before cleaning.
Do not use sharp objects to clean the product.
Do not allow any liquids to enter the product.
Otherwise the product could be damaged.
Do not use harsh or aggressive cleaning agents
such as thinners or petrol as these can dissolve
the plastic parts.
Clean the product regularly, preferably immedi-
ately after every use.
Clean the housing with a soft, dry cloth.

Disposal

The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
or
12
against the
16
and the double cou-
10
GB/IE/NI 9