Safety Cut Off; Switch Off - SKF TMVM 1 Mode D'emploi

Display:

Safety cut off:

The maximum measuring range was exceeded for 5 subsequent measurements.
The motor stops. When the main switch is pressed again the viscometer switches
off.
Display:
Safety switch off:
In case of electrical overload, the motor function is blocked. This will protect the
motor from damage.
4.1.3

Switch off

Action:
- Long press (3 seconds) the main switch to switch off the viscometer.
The display will indicate the remaining operating hours (xxx) before the
recommended calibration.
The last used rotor number is saved.
Display:
SKF TMVM 1
SAFETY CUT OFF
OVERLOAD
Service in xxx h
15