Introduction; Control Unit; Handling; Installation - Hendi 232903 Mode D'emploi

2. INTRODUCTION

This manual provides all necessary information on:
• operation of the appliance
• technical data
• installation and use
• guidance and indications for operators
• maintenance
This manual is an integral part of the appliance.
Keep the manual in a secure place for future ref-
erence.
NOTE
The manufacturer and/or seller accepts no liability for:
• Improper installation (inconsistent with guide-
lines provided in the manual)

3. CONTROL UNIT

The electronical control panel and power switch
are located in the top front part of the counter. The
switch is used to power on/off the appliance. If the
read LED is on, it indicates that the appliance is
powered and working. No active red LED means
that the appliance is disconnected and stopped.
The control panel is used to confi gure all param-

4. HANDLING

The appliance is supplied in PET foil packaging and
a cardboard box on a wooden pallet.
The appliance must be transported and handled
carefully to avoid any risk to persons or property.
Never place the appliance with a built-in refriger-
ating unit on its side or upside down as this may

5. INSTALLATION

• Position the appliance in the coolest and best
ventilated part of the room. Do not install the ap-
pliance in the vicinity of heat sources or exposed
to direct sunlight.
• Remove protective straps on the cardboard box.
• Improper operation of the appliance
• Power failures
• Improper maintenance
• Unauthorized changes or alterations of the
appliance
• Use of non-genuine spare parts
• Partial or complete failure to follow the manual
All electrical equipment may pose a health hazard.
It is mandatory to observe valid standards and legal
requirements during installation and operation of
the appliance.
eters necessary for proper operation of the appli-
ance. It is required to learn about the parameters
described in the manual supplied with the digital
control panel. The controller manual is part of this
manual, it is very important if the appliance must
be serviced.
damage the refrigerating unit. The manufacturer
and the seller shall not be liable for direct or in-
direct damage or faults due to improper handling
or failure to comply with the following guidelines.
Follow OH&S rules while transporting and/or han-
dling the appliance.
• Remove the cardboard sheet.
• Remove the protective foil.
• Wash the appliance with a mild agent. Dry up using
a soft cloth.
EN
5