Advice On Disposal - UFESA AC2000 Mode D'emploi

Carefully place the bag in such a way
that the hole in the bag plate was placed
over the rubber collar in the chamber of
the vacuum cleaner.
11
Close the cover until you hear the characteristic
clicking sound – be careful not to catch the bag.
Do not vacuum without bag. In case if
there is no bag in the vacuum cleaner,
the front cover of the vacuum cleaner
cannot be locked.
You should replace the bag, if:
a) the red field covers the bag full indicator,
b) the vacuum cleaner operates poorly,
c) the dust bag is full.
End of operation cleaning
and maintenance
1
Switch off the vacuum cleaner by pressing the "on/
off" button (3).
2
Unplug the appliance.
3
Wind the cord by pressing the cord rewind button (1).
While doing this hold the cord to make sure it is not
tangled and the plug does not hit the vacuum cleaner
housing.
4
Disconnect the suction tube from the suction
nozzle or brush.
5
Disconnect the suction tube from the hose.
6
Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the
vacuum cleaner.
7
The vacuum cleaner may be stored in a vertical
position – just place the fastening hook of the
combination brush into the fastening of the combination
brush. The hose may be connected to the vacuum
cleaner. Yet it is necessary to make sure it is not bent to
hard during storing time.
Horizontal storage:
– place the fastening hook of the combination brush
into its fastening placed at the back of the vacuum
cleaner, near the cord exit.
Vertical storage:
– place the combination brush on the telescopic tube,
– place the fastening hook on the telescopic tube into
the fastening of the combination brush placed on
the bottom of the vacuum cleaner, near the front
wheel.
8
If necessary wipe the housing and the dust bag
container with a damp cloth (it may be soaked with
dishwashing liquid) and dry it or wipe until dry.
Do not use abrasive detergents or
solvents
Examples of problems while operating
the vacuum cleaner
PROBLEM
The dust bag is
damaged.
The suction power
F
of the vacuum
cleaner is weak.
The electrical
installation fuse
went out.
The vacuum
cleaner does
not operate; the
housing or the
cord is damaged.

Advice on disposal

Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
This product complies with EU Directive
2002/96/EC. The crossed wheelie bin
symbol shown on the appliance indicates that
when it comes to dispose of the product it
must not be included in with household refuse. It must
be taken to a special refuse collection point for electric
and electronic appliances or returned to the distributor
when purchasing a similar appliance. Under current
ACTION
Remove the dust bag and the
filters.
Replace the dust bag and
the filters, check the suction
tube, the hose and the nozzle
– remove the cause of the
clogging.
Check if other appliances
are not plugged to the same
electrical circuit as the
vacuum cleaner. If the fuse
goes out repeatedly, return the
vacuum cleaner to a service
point.
Return the vacuum cleaner to
a service point.