UFESA AC2000 Mode D'emploi page 8

SUGGESTION
Information on the product
and suggestions for its use
●
The vacuum cleaner is for household use only.
●
Operate the appliance only in indoor spaces and
vacuum only dry surfaces. Before vacuuming dry
the carpets that were wet cleaned.
●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.
Technical parameters
The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
Does not require grounding
Vacuum cleaners meet the requirements of the applicable
norms.
The appliance is in conformity with the requirements of
the directives:
– Electrical equipment designed for use within specific
voltage limits (LVD) – 2006/95/EC.
– Electromagnetic compatibility (EMC) – 2004/108/EC.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 84 dB(A).
The appliance was marked by a CE sign on the rating
label.
Static electricity
In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
.
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1 Cord rewind button
2
Suction power regulation lider
3
ON/OFF button
4
Combination brush fastening
5
Handle
6
Plug and cord
7 Outlet filter cover
8
Bag repletion indicato
9
Front cover handle
10
Suction hose
11
Inlet filter (installed in the vacuum cleaner)
12
"Microfilter" outlet filter (installed in the vacuum
cleaner)
13
Telescopic suction tube with a fastening hook
14
SAFBAG dust bag (1 item)
15
Holder of the bag
16 Crevice nozzle
17
Small nozzle
18
Small brush
19
Switchable combination brush
Preparing the vacuum cleaner
for operation
1
Press the side button on the end of the suction hose.
2
Place the end of the suction hose in the vacuum
cleaner. You should hear a distinctive click, if you do it
right.
3
Attach the other end of the hose (the handle) to
the suction tube.
4
Adjust the length of the telescopic suction tube by
sliding the slider according to the arrow and pull out/
pull the tube together.
5
Assemble the appropriate nozzle or brush to the
other end of the suction tube.
6
Use combination carpet & floor brush for vacuuming
both hard surfaces and carpets. To clean hard surfaces
– wooden floors, plastic floors, ceramic tiles etc. pull out
the brush by pressing the switch on the combination
brush according to the figure
when vacuuming carpets (set the switch in "
A
B
. Retract the brush
").