Water Supply And Drain Connections; Preparing The Icemaker For Long Storage - Hoshizaki FM-170EE-HC Notice D'utilisation

ENGLISH
* The non-rewirable plug must never be used without
a fuse cover being fitted.
The correct replacement for the detachable fuse
cover is identifiable from the manufacturer 's
reference number stamped on the plug.
Supply of replacem ent fuse co ve r s c an be
obtained from Hoshizaki Parts/Service Centres.
Fuses should be rated at 13A and approved to BS
1362.
3. WATER SUPPLY AND DRAIN
CONNECTIONS
WARNING
Connect to potable cold water supply only.
Note: A plumbing permit and services of a licensed
plumber may be required in some areas.
* The connections to the mains water supply must
be made in accordance with the countries' current
requirements of the Water Supply or Water Fittings
Regulations.
* Icemaking water must be potable water. Where
scaling can be caused by water quality, installation
of an external filter or softener is recommended.
Contact your local water treatment professional or
Hoshizaki service agent.
II. OPERATING INSTRUCTIONS
WARNING
1. This icemaker is designed to produce and
store edible ice. To keep the icemaker
hygienic:
* Wash your hands before removing ice. Use
the plastic scoop provided (accessory).
* The storage bin is for ice use only. Do not
store anything else in the bin.
* Clean the storage bin before use (see "III. 1.
CLEANING").
* Keep the scoop clean. Clean it by using a
neutral cleaner and rinse thoroughly.
* Close the door after removing ice to
prevent entrance of dirt, dust or insects into
the storage bin.
2. All parts are factory-adjusted. Improper
adjustments may result in failure.
3. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the compressor.
1. OPERATION
The installer will normally commission the icemaker
to start the automatic icemaking process. To ensure
continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is plugged into the power supply.
2. PREPARING THE ICEMAKER FOR LONG
STORAGE
1) Run the icemaker with the water supply tap
closed.
2) Make sure the icemaking process has been
completed. Remove the inlet hose from the water
tap, and drain the hose.
3) Unplug the icemaker.
4) Remove all ice from the storage bin, and clean the
bin.
5) Ask for draining of the icemaker by professional
qualified personnel.
III. MAINTENANCE
1. CLEANING
WARNING
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
m a i n t e n a n c e o p e r a t i o n s , u n p l u g t h e
icemaker from the electrical supply network.
2. Ask a trained service person to clean the
condenser at least once a year.
3. This appliance must not be cleaned by use
of a water jet.
4. To prevent possible damage, do not clean
the plastic parts with water above 40°C or in
a dishwasher.
4