Setting Up Codes In The Installer Menu - Rotex RKRTR Manuel D'installation

4. Setting up codes in the installer menu

You can set up codes, starting from the time and date menu (in
advanced mode).
NOTE As a consequence of a customized configuration, it
is not abnormal that some codes are no longer
accessible.
1 Activate the advanced mode by pushing
seconds in OFF mode (
2 Navigate to the date and clock setting menu (
>
.
>
3 Press
during 10 seconds.
y
is displayed next to
<
4 Press
codes.
5 To modify codes, press
The value is flashing when being modified.
+
or
6 Press
1 step.
To put a code back to its default value, press
the same time.
=
7 Press to save your selection.
You can exit this code menu by going to the "
=
pressing
Refer also to "Overview of all codes" on page 17.
Installation manual
14
D
).
and keep it pressed while now pressing
4®
.
>
or to consult the current settings of the
+
,
-
to increase or decrease the code value by
.
- =
or .
RKRTR + EKRTETS
>
during 5
G
) by pressing
=
+ -
and at
/
" code and
Room thermostat
4PW50084-1