Ribimex RIBILAND PREHLS52N Guide D'utilisation Et Manuel D'instructions page 23

Keep your work area tidy! Untidiness can lead to accidents.
Avoid dangerous conditions
Always operate your log splitter on dry, solid, level ground.
Never operate your log splitter on slippery, wet, muddy, or icy surfaces.
The location you choose should be free from any tall grass, brush, or other
interferences.
There should be plenty of room for handling, and help the operator stay alert.
To avoid tripping, do not leave tools, logs, or other components laying around the
work area.
Do not use it in areas where fumes from paint, solvents or flammable liquids pose a
potential hazard.
During operation, firmly hold log with log holder claws.
Inspect your log splitter
It is prohibited to remove or modify guards and safety mechanisms.
Check your log splitter before turning it on.
Keep guards in place and in working order.
Do not disassemble or modify the protective devices or the log splitter.
Form a habit of checking to see that keys and adjusting wrenches are removed from
tool before turning it on.
Replace damaged, missing or failed parts before using it.
Make sure all nuts, bolts, screws, hydraulic fittings, hose clamps, etc. are securely
tightened.
Always check the oil level in the hydraulic oil tank.
Never operate your log splitter when it is in need of repair or is in poor mechanical
condition.
Before starting work, hydraulic pipes and hoses shall be inspected and stopping
devices shall be tested.
Avoid injury from unexpected accident.
Cutting and crushing hazard! Never touch dangerous parts when the splitting
knife is moving.
Always pay full attention to the movement of the splitting knife
Danger! Keep clear of moving parts!
Do not straddle or reach across the splitting area when operating the log splitter. Never
pile logs to be split in a manner that will cause you to reach across the log splitter.
Only use your hands to operate the control levers.
Never use your foot, knee, a rope, or any other extension device.
Always pay full attention to the movement of the wedge / log pusher ram.
Never attempt to load your log splitter while the ram is in motion.
Keep hands out of the way of all moving parts.
Never try to split two logs on top of each other. One of them may fly up and hit you.
Do not place any tool or any part of your body in the log splitter during operation.
Disconnect power
Attention! Disconnect product from power supply: before maintenance, cleaning,
making adjustments or changing parts or any intervention on product; before opening
motor cover; before moving or transporting product; or when not in use.
Consult manual before servicing.
Disconnect product from its main power source, if product, power cable, or extension
cord is damaged or cut during operation.
Unplug product by pulling the plug. Do not pull the cable.
Page 23 / 59