Ribimex RIBILAND PREHLS52N Guide D'utilisation Et Manuel D'instructions page 34

5.7- Tips
When the ambient temperature is below -5°C: let the log splitter run for at least 5-10 minutes with no
load so that the oil can heat.
Never force the log splitter for more than 5 seconds by keeping pressure on it to split
excessively hard wood! After this time interval, the oil under pressure will be overheated and the
machine could be damaged.
For such extremely hard log, rotate it by 90° to see whether it can be split in a different direction.
In any case, if you are not able to split the log, this means that its hardness exceeds the capacity of the
machine and thus that log should be removed to protect the log splitter and cut using other tools.
Do not attempt to split green logs.
Dry, seasoned logs split much more easily, and will not jam as frequently as green wood.
Never attempt to split logs containing nails, metals parts or any other hard piece.
Only split logs whose length is smaller than the capacity of the machine (refer to specifications).
Set and split the log in the direction of its growing grain.
Do not place the log across the log splitter for splitting. It may be dangerous and may seriously damage
the machine.
Do not attempt to split 2 pieces of logs at the same time. One of them may fly up and hit you.
Stack as you work. This will provide a safer work area, by keeping it uncluttered, and avoid the danger
of tripping, or damaging the power cord.
Accumulated split wood and wood chips can create a hazardous work environment. Never continue to
work in a cluttered work area which may cause you to slip, trip or fall. Keep your work area clean and tidy.
WARNING! Do not become careless in assuming your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the
tool, neglecting strict compliance to the safety instructions given with the tool.
Improper us of the tool or failure to comply with the provided safety instructions in
this manual can cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Stay alert for your surroundings and especially for any danger that you may not
hear while using the tool.
Page 34 / 59